Announcement

Collapse
No announcement yet.

A Post door seals. Help !

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • RogerS
    replied
    Thanks DJT,

    I have googled photos of Triumph Stag doors and from my findings my seals are short by approx 150 mm. I have ordered new from Robsport, plus an additional one in case they too are short, I can then extend if necessary.

    Roger S

    Leave a comment:


  • staginmacc
    replied
    Thanks very useful, I will refit like that.
    great help appreciated on this forum as always!

    Leave a comment:


  • jbuckl
    replied
    +1 for djt

    Leave a comment:


  • DJT
    replied
    Does this help?

    Seal.jpg

    Leave a comment:


  • staginmacc
    replied
    I put mine on the wrong way now I read this. So if the bulb is outward is the thin edge held captive inside the fur flex or just butted to side of the seam? Not sure about the final position on inside, please confirm if possible. Regards Paul

    Leave a comment:


  • Phil S
    replied
    I recently fitted new door seals, great service from Robsport they were cut to correct length. other suppliers availablešŸ¤£

    Leave a comment:


  • trunt
    replied
    If I recall properly they were originally taped to the lip with something like duct tape not glued except the last few inches then the fur flex is fitted over the tape. the bulb is to the outside as you have them now

    Terry
    Last edited by trunt; 23rd May 2020, 13:56.

    Leave a comment:


  • RogerS
    started a topic A Post door seals. Help !

    A Post door seals. Help !

    Hi Guys

    Not had the Stag long, get caught out in a heavy shower this morning with the soft top on and water peed in between the A post rubbers and the door frame., it runs down the rubber, once it reaches the bottom of the rubber it drips onto the sill.and into the car.The rubbers seals are stuck on and not in good condition and squashed flat. ( See photos ) so I will replace them.My questions are as follows. The replacements from Rimmers appears to be Ref 630755.? Also have mine been stuck on the correct way around ?, Rimmers diagram suggests not, this shows the tube section of the rubber innermost to the main door rubber, whilst mine is the opposite ?.Are my rubbers short ? should they extend further down the post ?
    I had the car painted before taking delivery, so never really noticed the rubbers, I know they were removed and stuck back by the body shop, as my record photos indicate.

    Just a note,I had the main door rubbers replaced.so I know they are ok.

    Thanks all.

    Roger S
    Attached Files
Working...
X