Announcement

Collapse
No announcement yet.

triumph stag

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    triumph stag

    does anyone have a reamer for the small end bush for a stag con rod?
    also after a set of circlips for the pistons / gudgeon pins.
    thanks
    mark

    #2
    The little end bearing has an 80 micron clearance fit. It should be machined then honed to size. A reamer is not correct for finishing the small end bush. The circlips are supplied with new pistons. Taking other routes are risky. Sorry to say. Last winter I fitted a new small end bush. The honing was done by mja bromsgrove and wasn’t that expensive. the machinery is very expensive...6k. Atb
    Last edited by jbuckl; 1st January 2020, 23:32.
    There are 2 secrets to staying on top :- 1. Don't give everything away.
    2.

    Comment


      #3
      thanks for the information
      mark

      Comment

      Working...
      X